Octaform Snap-Trim

Now anyone can finish like a pro…

Ceiling Trim PVC Ceiling Panels Ceiling Covered And Trimmed

Whether you need to trim an opening or fix a mistake, Snap-Trim makes it possible for anyone to finish like a pro. Just fasten an anchor strip and snap a beautiful finishing cap in place.

No more patches or improvising. Just a professionally finished facility in a fraction of the time.

 

Octaform-Snap-Trim

MULTI-TRIM finishes your base or crown. Optionally, the hollow channel can be used to feed data or other low voltage cables.

MULTI-TRIM finishes your base or crown. Optionally, the hollow channel can be used to feed data or other low voltage cables.

OUTSIDE CORNERS finish quickly with little fuss. Just fasten the base and the cap snaps in place, leaving a great-looking rounded corner.

OUTSIDE CORNERS finish quickly with little fuss. Just fasten the base and the cap snaps in place, leaving a great-looking rounded corner.

FOOD SAFE FACILITIES require that inside corners be coved. Installing corner trim is now literally, a snap. Base strip can fasten to flat wall, corner or both.

FOOD SAFE FACILITIES require that inside corners be coved. Now, it’s a snap. Base strip can fasten to flat wall or corner.

Finish quickly and professionally at any wall location. aLso: Easily replace damaged or vandalized panels without removing and re-installing multiple interlocking panels.

Finish like a pro, fast.
ALSO: Easily replace damaged or vandalized panels without removing and re-installing interlocking panels.

 

Snap-Trim Makes Repairs Simple

 

Fork-Lift-Animate

Repair PVC Panels in a Snap!

Previously, smashed or vandalized panels left wall owners with two not-so-great options: repair (filler, paint – hopefully a match) or replace. Replacing a damaged panel is always the most desirable option but weighed against the headache of removing and re-inserting multiple pieces of interlocking PVC, many opt for some sort of patch. 

With Octaform’s new snap-in finishing trim, you can now replace single panels in just a fraction of that time.  Simply cut out and replace the affected area – and with Octaform’s two-piece trim system, finishing is literally a snap. An anchor strip fastens easily between the panels, allowing a finishing cap to be snapped in place.

 

 

See How Easy It Can Be

1. Remove
2. Replace
3. Trim

Cut-Remove-Animate

Cut and remove the affected section of panel. Fastened section remains on wall.

Measure-Replace

Measure and replace with new section of panel, leaving 1-5/8″ for Snap-Trim and 1/32″ at seam.

Install-Trim

Fasten Snap-Trim base leaving 3/16″ on either side. Cap snaps in place, leaving a beautiful finish.

 

Shipping Now With:
Quick-Liner-Logo-1


Questions? Call 1-888-786-6282 (OCTA)